Socket Outlet (in Indonesia "Stop Contact") is electrical component that serves as a liaison between the flow of electricity to the electrical equipment. stop contact is also commonly referred to as an outlet. In order to stop this contact can be connected with an electric current, the use of carriage and plug as conductor .
 |
| Stop Contact |
stop contact has a construction on the tube-blown horns that are spring-loaded, so that at the time the plug in type, is not easily detached and became important for efficiency and security.
The maximum capacity of an electrical current of this contact is a stop of 10A-16A (equivalent to voltage 2200VA – 3300 VA for standard voltage 220 V). But the maximum use of the maximum of this contact deibatasi stop by the magnitude of the power subscribed from the electric company and also of the material from the stop contact itself, where the better the quality of their material, of course it will also be more expensive.
Based on the place of installation, there are two types of stop contacts, namely
- stopcontactin-bow, stopcontactsused oninstallation ofembeddedin thewall
- stop contacts out-bow, i.e. stop contacts are mounted on the surface of the wall.
In home installation, stop contacts are mounted at least a minimum of one point in each room. This is necessary to avoid the use of the stop excessive load on contacts with the ditancap plug.
In the installation and the wire diagram, based on general rules fixing stop contacts in Indonesia was a must have terms as follows:
- mountingHeight± 150cmabovethe floor,and if it isless than150 cm,then it should be complemented byclosed.
- install in a place which is easily accomplished in hand
- Installed such that the neutral conductor is to the right or below, the grounding is in the middle and the phasanya is on the left.
- colour marking on the grounding penghatar (yellow with green strips), the neutral conductor (blue), and L-phase Motors (red, yellow, or black).
0 Response to "COMPONENT OF SOCKET OUTLET"
Post a Comment